Chicago® Grip - Dual Conductor Trans
1628-40VR
- Made in USA and designed specifically for VR2® (vibration-resistant) and TransPowr® T-2® dual conductor twisted pair cables
- Machined upper and lower jaws eliminate scoring or damage to second conductor by contouring to second conductor
- Round jaws shaped to provide maximum contact with circumference of cable and prevent cable deformation
- Supplied with spring and locking loop handles, allows jaws to be held in open position for easier placement on cable
- Grips maintain temporary tension until the wire or cable can be permanently terminated
- Orders must specify exact outside diameter of cables, circular mills with strand combination, or manufacturer's code
- VR2 is a registered trademark of Southwire Company
- TransPowr and T-2 are registered trademarks of General Cable Technologies Corporation.
The ÌÒ×ÓÊÓƵ Chicago® Grip - Dual Conductor Trans is designed specifically for VR2® (vibration-resistant) and TransPowr® T-2® dual conductor twisted pair cables. The machined upper and lower jaws eliminate scoring or damage to second conductor by contouring to second conductor. The round jaws are shaped to provide maximum contact with circumference of cable and prevent cable deformation.
Specifications
Type:
Chicago Grip
Special Features:
Specially milled jaws for the Vibration Resistant twin conductor
Cable Type:
ACSR, AAC
Cable Diameter:
0.95'' to 1.27'' (24.13 to 32.3)
Hot Latch:
N
Swing Latch:
N
Spring:
N
Locking Handle:
N
Jaw Type:
Round
Maximum Safe Load:
15,000 lb (6803 kg)
Weight:
1.6 oz (45 g)
UPC:
092644470509
Additional Information
Warnings
- Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
- Always match proper size and type of grip to application.
- Do not exceed rated capacity.
- When used on/near energized lines, ground, insulate, or isolate grip before pulling.
- Grips are to be used for temporary installation, not for permanent anchorage.
